image not available

Dr. Ranjan Basak

Designation: Assistant Professor

Email :

Mobile : 09434189483

Contact Address :

MECHANICAL ENGINEERING DEPARTMENT
NIT SIKKIM
Ravangla
South Sikkim
Sikkim -737139


Experience

13 years

Teachings

Engg. Mechanics,
Strength of Materials,
Engg. Graphics,
Fluid Mechanics,
Hydraulic machines,
Kinematics of Machines,
Dynamics of Machines,
Advanced Fluid Mechanics,
Dynamics of Machines Lab.

Education

ME - Jadavpur University
PhD - Jadavpur University

Areas of Interest

Fluid Mechanics,
Machine Design

Publications & Extras

Journal Publication

1. R. Basak, D. Mitra, "Wide Angle Diffuser Design Using Two Cubic Profiles for Open Circuit Wind Tunnel", International Journal of Advances in Science and Technology, 2011, Vol. 2, No.4, 83-87.

2. R. Basak, D. Mitra, A. Mazumdar, "Design of Various Components of an Open Circuit Blower Tunnel without Exit Diffuser", International Journal of Advances in Science and Technology, 2011, Vol. 2, No.6, 88-93.

3. D. Mitra, R. Basak, N. Sarkar, D. Paliwal, "A Note on Prevention and Control of Sulfur Oxide Pollution", International Journal of Engineering Science and Technology, 2010, Vol. 2, No.8, 3926-3928.

4. D. Paliwal, N. Sarkar, R. Basak, D. Mitra, "Biomass as an Alternative Source of Energy in India", International Journal of Engineering Science and Technology, 2010, Vol. 2, No. 10, 5457-5461.

5. D. Paliwal, N. Sarkar, R. Basak, D. Mitra, "Minimum Height of Environment-Friendly SO2 Emitting Stacks", International Journal of Advances in Science and Technology, Vol.1, No. 3, 63-68.

Conference Publication

1. A paper entitled "A Comparative Study on Design and Manufacturing of Ultrasonic Immersion Testing Fixture" has been published in the proceedings of 4th International Conference on Mechanical Engineering (ICME-2001), held in BUET, DHAKA from 26-29 December 2001.

2. A paper entitled "An Exotic Design of a Fixture for Ultrasonic Immersion Testing Equipment-a new approach" has been published in the proceedings of 2nd International Conference on Manufacturing (ICM-2002) organized by the Industrial and Production Engineering Department, BUET, held during August09-11, 2002 at BUET campus, Dhaka.

3. A paper entitled "A computer Aided Analysis of front slide-Cam of Automatic Screw Machine" has been published in the proceedings of AIMTDR-2002 conference held in BIT, MESRA in December 2002.